Bucket Car Progress

My scratchbuilt model of bucket car AC 10591 has continued to make some good forward progress this weekend. Both this car and boom car 10588 now have a styrene floor, and basic bolsters and a piece of lead sheet glued in for weight, and this evening I made some additional progress on a basic interpretation of and underframe for 10591. The second car is yet to be done, but will be similar.

IMG_5604

The cars were rebuilt from flatcars, so in addition to the interesting fish-belly side reinforcements, the cars have a heavy fish-belly centre sill underframe as well. I just have a few more pieces of bracing to fabricate, and then adding brake detail to the underframe.

Also on one end of the 10591 is this large boxy structure. I’m not entirely sure of its purpose but suspect it to be an oil tank of some sorts. Most of the photos I have of the car are all from the end with the box, making visual inspection of the inside face of it difficult. What can be seen from any angle, however, is a large vent on top, and what appears to be a lifting ring in the middle of the top surface (possibly attached to an access or filling hatch?). This 1981 wreck photo from Ted Ellis shows the railway’s wreck crane in action, with this bucket car included in the train, and provides a partial view of the inside face of the box. From what is visible here, the face appears mainly plain, with no doors (so it’s does not appear to be a storage cabinet), although a short drip strip across the middle third of the top edge is interesting. Perhaps there is a drain valve or some sort of access hatch to such at the bottom?

IMG_5606

I’m hoping to find some ex-ACR guy that might remember this car and might be able to confirm those details, but in the meantime I’ve progressed with fabricating the box structure itself and the top vent. I’ll continue on with other details for now, but if I don’t find any more information I’ll just have to go with my best guess for the details to apply.

7 thoughts on “Bucket Car Progress

  1. Chris,

    Nice work on an interesting prototype. Will you be applying archer rivets to these cars? I am about to try them out for the first time and was wondering if you have any experience with them or tips to share?

    Ryan

  2. Very nice models, and thank you for sharing your construction techniques. Since I’m not as skilled as you, would kit-bashing the Accurail 41′ gondolas be a reasonable facsimile of what you are doing? They also make parts for a fish belly floor/underframe as well. Just a thought…..
    Phil G.
    WCL modeller

    • I’m not sure you could really replicate the unique open drop sides on these particular cars nicely without scratchbuilding the side, as the rib has to extend all the way down to the bottom brace. You could try blending with the existing ribs…

      On the other hand, there were a few other varieties of gondolas sliced and diced in various ways as boom and bucket cars…

      I have a saved photo of 10580, which is an ex-3500 series 48′ gondola converted to a boom car along the same lines as 10587 + 10588.

      I’ve also seen a pair of cars – 10715, converted from a 4800 series gon like 10588, and another car with lettering not legible converted from a 48′ gon – with a large part of the superstructure cut away and apparently used as bucket cars.

  3. Any chance you can share what styrene pieces you used to make the under frame and bolters? Where the side meets the end what piece of styrene did you use there? Also what did you use for the horizontal braces on the ends? On your drawing what is the total length of the sides? How long are the side posts and spacing? I have all the other sizes of styrene. Sorry so many questions just would like to duplicate such a great model. Really looks good.

    Thank you
    Joe

Leave a Reply to Joe Vincent Cancel reply

Your email address will not be published. Required fields are marked *


one × = 2