Speeder Shed Doors

I was able to get some more progress completed this evening on my trio of speeder sheds and the three buildings now have doors.


The doors are made from a back cut from a sheet of Evergreen V-groove siding in an .040″ spacing, with .01″x.04″ top and side framing, and .01″x.06″ bottom and middle bracing, as close inspection of the prototype photo shows that the lower bracing is made up of wider boards than the top and side edges.

ACR From Blair 048 (2)

(Above photo courtesy Blair Smith.)

Below you can see the three model doors in various states of completion showing the sequence of construction.


Leave a Reply

Your email address will not be published. Required fields are marked *

four − = 1