![\"\"](\"https:\/\/vanderheide.ca\/blog\/wp-content\/uploads\/2018\/08\/035-2.jpg\")
<\/a><\/p>\nThe box is made from 3\/16″ foam core board and has overall dimensions of (roughly) 10×10″ (precisely, it’s 9 15\/16″ wide by 10 5\/16″ deep to account for the internal size of the pockets plus the width of all the material) with 24 (4×6) sorting\/storage slots that are 2 1\/4″ wide x 1 1\/2″ deep to fit the waybill cards. The depth of the outer walls is 4″, the depth of the inner pocket dividers are 3″. I cut a drop in the front of the box down to match the 3″ depth of the pockets to made it easier to see and access the front row(s) of waybills. The central dividers are notched halfway up where they cross each other to form a simple but sturdy interlocking series of halved joints (like this: https:\/\/en.wikipedia.org\/wiki\/Halved_joint ) I didn’t glue the dividers to each other due to the nice tight fit of the halved joints, but glued the whole divider assembly, the outer walls and base together with regular white glue.<\/p>\n
The labelled card dividers within each pocket are just pieces of card stock (actually just the trimmings of the car card sheet after the car cards are cut out) cut slightly longer than the waybills so they stick up above them.<\/p>\n","protected":false},"excerpt":{"rendered":" Just a small project this weekend to make a proper storage and sorting box for my waybills. All cut out of a single sheet of 20×30\u201d foam core board. The box is made from 3\/16″ foam core board and has … Continue reading <\/a><\/p>\n